How To Modify / Skeleton The Andis Slimline Pro Li

How To Modify / Skeleton The Andis Slimline Pro Li


Hello everyone and welcome to another
60-second barber tips. In our last video we showed you how we modified the
cordless T Outliners. If you haven’t seen it we have put a link at the top of the screen.
Whilst doing this modification we decided that we would also modify the
Slimline Pro, to see if it perform better. In this video will show you how we did
it. We have listed all the equipment needed
for this modification in the description below. Begin by marking out the section to
be cut. Put the cutting disc on the multi-tool and start cutting along the
guide line. Make sure to follow the Dremel safety instructions and wear
goggles. Next attach the sander and remove all the rough edges. Finally, refine with some sandpaper. And
here is the finished cut. You can reattach the original blade for fit a T Outliner blade like we’ve done here. Our video about how to do this is linked in
the description below. Thanks very much for watching and we’ll see you in the
next 60 Second Barber Tips.

Leave a Reply

Your email address will not be published. Required fields are marked *