How to Replace the Display Panel | HP Pavilion 15z-ec000 CTO | HP

How to Replace the Display Panel | HP Pavilion 15z-ec000 CTO | HP


How to replace the Display Panel Before you begin: Remove the base enclosure, WLAN module, display panel assembly, and display bezel. Removal – IMPORTANT: The display panel is held in place by two strips of stretch-release tape. Each tape strip has a plastic pull-tab attached to one end. One at a time, grasp the pull-tab of each strip of tape And carefully wrap it around the end of a
cylindrical tool such as a screw driver. Slowly twist the tool to release the tape. Continue twisting until the entire strip has
been removed. IMPORTANT: If the stretch-release tape strips are pulled too quickly or at an extreme angle, They will break before releasing the display panel. NOTE: The removed stretch-release tape is not reusable. Lift the display panel off the display enclosure and turn it over to gain access to the display panel cable connector. Peel back the retention tape and disconnect the display panel cable from the connector on the display panel. Remove the display panel. IMPORTANT: Please refer to the maintenance And service guide for instructions on replacing the display panel. The stretch-release tape strips that secure the display panel to the display enclosure must to be placed in a specific orientation.

Leave a Reply

Your email address will not be published. Required fields are marked *